Running PNPENABL.EXE using the command line

Running PNPENABL.EXE using the command line

PNPENABL.EXE automatically locates and configures the AT PnP Ringnode.

For multiple Madge PnP Ringnodes, PNPENABL.EXE locates and configures them using any available I/O addresses and IRQ channels. If you specify the /IO and /INT options, then the first adapter card found by PNPENABL.EXE is assigned these values.

To run PNPENABL.EXE from the command line, type the following at the DOS prompt:

PNPENABL <command-line options>

[Previous page]

[Using Madge Wizard][Ringnode Installation][Driver Installation][Software Utilities][Additional Information]

____________________