DOS error levels returned by PNPENABL.EXE

DOS error levels returned by PNPENABL.EXE

The following table displays the DOS error levels returned by PNPENABL.EXE on exit:

DOS error levelMessage
0Success
1Not used
2Bad I/O address given with /IO=
3Bad MEM address given with /MEM=
4Bad IRQ channel given with /INT=
5No PNP adapters found
7Unable to deactivate the card
8Unable to set the IRQ channel
9Unable to set the IRQ type
10Unable to set the I/O base address
11Unable to set the MEM base address
12Unable to activate the card

[Previous page]

[Using Madge Wizard][Ringnode Installation][Driver Installation][Software Utilities][Additional Information]

____________________