Running a single Wizard from the Madge Wizard suite

To run Madge Wizard using command-line options, boot your computer, then at the DOS prompt type:

MWIZARD <command-line options>

The command-line options that you can use to run a Madge Wizard utility in isolation are:

Use this command-line option: If you want to:

NEWNODE Run New Ringnode Wizard (Install a new ringnode).

TESTNODE Run Test Ringnode Wizard (Test a Ringnode).

HARDWARE Run Hardware Wizard (Change Ringnode configuration).

SOFTWARE Run Software Wizard (Set up Software).

DOCS Run Documentation Wizard (Read documentation).

DECOMPRESS Decompress MWIZARD.EXE and all *.WIZ files (Wizards).

COMPRESS Compress MWIZARD.EXE and all *.WIZ files (Wizards).

Use this command-line option:	If you want to:
NEWNODE	Run New Ringnode Wizard (Install a new ringnode).
TESTNODE	Run Test Ringnode Wizard (Test a Ringnode).
HARDWARE	Run Hardware Wizard (Change Ringnode configuration).
SOFTWARE	Run Software Wizard (Set up Software).
DOCS	Run Documentation Wizard (Read documentation).
DECOMPRESS	Decompress MWIZARD.EXE and all *.WIZ files (Wizards).
COMPRESS	Compress MWIZARD.EXE and all *.WIZ files (Wizards).