Running a hardware configuration script file

Running a hardware configuration script file from the command-line

To run a configuration script from the command-line, type at the DOS prompt:

MWIZARD HARDWARE LOAD=<NAME OF SCRIPT FILE>.HWR [ENTER]

To turn off all warnings and errors when you run a script, type at the DOS prompt:

MWIZARD HARDWARE LOAD=<NAME OF SCRIPT FILE>.HWR NOSCRIPTERRORS [ENTER]

Caution: If you run a script file with all warning and error messages turned off, you may cause device clashes in your computer.

[Back]

[Using Madge Wizard][Ringnode Installation][Driver Installation][Ringnode Config and Diag][Additional Information]

____________________