Running a software configuration script file

Running a software configuration script file

Note: When you run a script Madge Wizard will access files from the LSS CD. If you do not have the LSS CD present then Madge Wizard will request Release Disk 2 instead.

To run a configuration script using Madge Wizard:

  1. Type MWIZARD SCRIPTING [ENTER] at the DOS prompt.

  2. Click on "Set up software".

  3. Select "Load following script". Type the name of the script file that you want to run, then click on "OK".

  4. Click on "Maintain". The Select script file window appears.

The command-line options that you can use when you run a software script are:

Use this command-line option:If you want to:
MWIZARD SOFTWARE DIR=<pathname>The directory and drive to read set up from, and write to for software installation.
MWIZARD SOFTWARE MENU=<menu item>The DOS 6 menu item to read from during software installation.

[Back]

[Using Madge Wizard][Ringnode Installation][Driver Installation][Ringnode Config and Diag][Additional Information]

____________________